表面粗糙度对玻璃钢材料放气速率影响的试验研究

设计了一套基于压差流量法的试验装置来测量不同表面粗糙度玻璃钢试样的放气速率;采用两种砂纸(100#和500#)打磨而得到两种不同表面粗糙度玻璃钢试样;采用扫描探针显微镜对试样表面粗糙度进行测量,测量了不同表面粗糙度试样在不同温度下的放气速率。试验结果表明:测量室温度越高,玻璃钢试样的放气速率越大;试样的表面粗糙度越大,其放气速率越大。     

新型共沸混合工质HC170／FC116沸腾传热实验研究

实验测量了新型共沸混合工质HC170/FC116的池核沸腾传热特性.实验测量的加热面为紫铜表面,热流密度范围为50 kW/m2～300 kW/m2.同时实验结果与复叠温区常用制冷剂R503和R508B的传热性能进行了比较,发现新型共沸混合工质HC170/FC116的传热性能高于R508B.最后对实验数据回归得到了共沸混合工质传热系数计算关联式,此关联式的计算值与实验数据的偏差在士10%以内.     

5-(4-丙氨酸丁氧苯基)-10,15,20-三苯基卟啉及其配合物的合成和性质

本文首次合成了一种新型的单取代的丙氨酸四苯基卟啉，５－（４－丙氨酸丁氧苯基）－１０，１５，２０－三苯基卟啉（Ｈ２Ｌ），及其Ｃｏ（Ⅱ）、Ｃｕ（Ⅱ）、Ｚｎ（Ⅱ）配合物（ＣｏＬ、ＣｕＬ、ＺｎＬ），用元素分析、电子光谱、红外光谱、荧光光谱和激光拉曼光谱进行表征。研究了ＭＬ存在下，用氧气氧化芳醛的过程，测定了反应体系的吸氧动力学曲线，研究了氧化过程金属卟啉可见光谱变化以及底物和金属卟啉浓度对反应的影响。结果表明，ＣｏＬ能加速芳醛氧化反应，最大吸氧速率随ＣｏＬ浓度的增加而增大，但反应诱导期随ＣｏＬ浓度增大而延长。     

动力学电位法测定硼

本文根据硼酸，苯乙醇酸，孔雀绿形成三元离子缔合型配合物的反应，用孔雀绿离子选择性电极监测反应速率，在最佳实验条件下，用固定时间法，电位变化与硼量在０．２－５．０μｇ／ｍＬ范围呈线性关系，用於测定标准钢样和玻璃标样中的硼，结果与标准值十分接近。     

维生素C溶液有氧降解动力学

建立了一种恒温高压氧药物稳定性加速试验方法, 用这种方法可在较短的时间内求得药物氧化反应的动力学参数. 以10%维生素C溶液为例, 维生素C在有氧和无氧条件下均可降解, 总的降解速率常数k_t由两部分构成: k_t＝k_an＋k_ae, k_an为无氧降解速率常数, 可表达为k_an＝A_an•exp(－E_a,an /RT); k_ae为有氧降解速率常数, 可表达为k_ae＝A_ae•exp(－E_a,ae/ RT)• .     

HPLC determination of four active saponins from Panax notoginseng in rat serum and its application to pharmacokinetic studies

Four main active saponins (ginsenosides Rg1, Rb1, Rd and notoginsenoside R1) in Panax notoginseng in rat serum after oral and intravenous administration of total saponins of P. notoginseng (PNS) to rats were determined using a simple and sensitive high-performance chromatographic method. The serum samples were pretreated with solid-phase extraction before analysis. The calibration curves for the four saponins were linear in the given concentration ranges. The intra-day and inter-day assay coefficients in serum were less than 10.0% and the recoveries of the method were higher than 80.0% in the high, middle and low concentrations. This method was applied to study the pharmacokinetics following oral and intravenous administration of PNS.     

Synthesis and aqueous solution properties of sterically stabilized pH-responsive polyampholyte microgels

Emulsion copolymerization of poly(methacrylic acid) and poly(2-(diethylamino)ethyl methacrylate) (PMAA/PDEA) yielded pH-responsive polyampholyte microgels of 200-300 nm in diameter. These microgels showed enhanced hydrophilic behavior in aqueous medium at low and high pH, but formed large aggregates of approximately 2500 nm at intermediate pH. To achieve colloidal stability at intermediate pH, a second batch of microgels of identical monomer composition were synthesized, where monomethoxy-capped poly(ethylene glycol)methacrylate (PEGMA) was grafted onto the surface of these particles. Dynamic light-scattering measurements showed that the hydrodynamic radius, Rh, of sterically stabilized microgels was approximately 100 nm at intermediate pH and increased to 120 and 200 nm at pH 2 and 10, respectively. Between pH 4 and 6, these microgels possessed mobility close to zero and a negative second virial coefficient, A2, due to overall charge neutralization near the isoelectric pH. From the Rh, mobility, and A2, cross-linked MAA-DEA microgels with and without PEGMA retained their polyampholytic properties in solution. By varying the composition of MAA and DEA in the microgel, it is possible to vary the isoelectric point of the colloidal particles. These new microgels are being explored for use in the delivery of DNA and proteins.     

超临界苯类溶剂对聚苯乙烯降解的影响

在高压间歇反应器中,温度340~370℃,以苯、甲苯、乙苯和对二甲苯为超临界溶剂研究了聚苯乙烯(PS)的降解特性.苯类物质是聚苯乙烯的优良溶剂,在超临界条件下其优异的传质、传热性能使聚苯乙烯快速降解.聚苯乙烯在不同超临界溶剂中降解转化率相近,而降解产物组成差别很大,分析了不同超临界溶剂对聚苯乙烯降解过程的影响.结果表明超临界甲苯对降解过程影响最小,苯乙烯收率最高.聚苯乙烯降解过程中,高分子链断裂和解聚同时进行,结合连续分布理论建立了聚苯乙烯降解的动力学模型,得到在超临界甲苯中聚苯乙烯链端解聚活化能为138.4 kJ.mol-1.     

N(1)取代5-氟尿嘧啶乙酸、5-氟尿嘧啶丙酸与Cu(Ⅱ)、Co(Ⅱ)、Ni(Ⅱ)、Zn(Ⅱ)、Mn(Ⅱ)的配合物的合成及表征

合成了N(1)取代5-氟尿嘧啶乙酸、5-氟尿嘧啶丙酸与铜(Ⅱ)、钴(Ⅱ)、镍(Ⅱ)和锰(Ⅱ)的十种金属配合物。通过元素分析、差热-热重分析确定了它们的化学组成,并对这些化合物进行了红外光谱、氢核磁共振谱,电子光谱的表征。讨论了各配合物中金属离子与配体的配位状态。在Cu(Ⅱ)配合物中,Cu(Ⅱ)是与配体的N³原子和C⁴上的羰基氧原子配位,其他金属配合物中,金属离子是与配体的C²的羰基氧原子和羧基配位。     

用列队竞争算法解旅行商问题

给出了列队竞争算法解组合优化问题的框架和确定变异邻域的两条原则。用列队竞争算法解旅行商问题获得了满意的结果,显示出列队竞争算法良好的全局搜索性能。